Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
If problems occur with the button keypad, this guide will show the user how to thoroughly clean them.
Cosa ti serve
-
-
Starting from the top of the cover, slide down and away from the phone with your thumb
-
Lift battery cover off of batter and place it to the side
-
-
-
Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle
-
Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
-
Place battery pack to the side
-
-
-
Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)
-
-
-
-
Carefully remove the middle two 7mm screws, the outer top 9mm screws, and the top middle 7 mm screw that hold the logic board to the front shell of the phone casing using the Phillips #1 screwdriver
-
-
-
Remove the white plastic sheet covering the button pad with your fingers
-
Gently remove the silicon button pad
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.