Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

If your URPOWER V2 Ultrasonic Aroma Essential Diffuser is making a buzzing noise, use this guide to replace the Coolcox CC5010M12S fan. The fan can have a faulty blade that creates a buzzing noise when on.

Before beginning make sure there is no water in the device.

  1. Unplug the Oil Diffuser. Unplug the Oil Diffuser. Unplug the Oil Diffuser.
    • Unplug the Oil Diffuser.

  2. Using a Phillips #00 screwdriver from the iFixit kit, remove all three 10.0 mm screws on the bottom piece. Using a Phillips #00 screwdriver from the iFixit kit, remove all three 10.0 mm screws on the bottom piece.
    • Using a Phillips #00 screwdriver from the iFixit kit, remove all three 10.0 mm screws on the bottom piece.

  3. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Acquista ora

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Acquista ora
  4. Remove the bottom piece of the Oil Diffuser.
    • Remove the bottom piece of the Oil Diffuser.

    • Be careful not to lose the outside light and air buttons.

  5. Unplug the fan power cord. Unplug the fan power cord.
    • Unplug the fan power cord.

  6. Using the Phillips #00, remove two 10.0 mm screws holding the fan onto the base of the diffuser. Using the Phillips #00, remove two 10.0 mm screws holding the fan onto the base of the diffuser.
    • Using the Phillips #00, remove two 10.0 mm screws holding the fan onto the base of the diffuser.

  7. Remove and replace the fan.
    • Remove and replace the fan.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Lilian Kay

Membro da: 07/10/2019

133 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 12

Ultimi 30 Giorni: 50

Tutti i Tempi: 450