Salta al contenuto principale

UP! Plus 2 Extrusion Head Fan Replacement

Cosa ti serve

  1. UP! Plus 2 Extrusion Head Fan Replacement, Remove fan cover: passo 1, immagine 1 di 2 UP! Plus 2 Extrusion Head Fan Replacement, Remove fan cover: passo 1, immagine 2 di 2
    • Remove the plastic cover that sits on the extruder, next to the fan, by lifting the latches in the back. The latches should lift right out.

  2. UP! Plus 2 Extrusion Head Fan Replacement, Remove fan: passo 2, immagine 1 di 2 UP! Plus 2 Extrusion Head Fan Replacement, Remove fan: passo 2, immagine 2 di 2
    • Using the Phillips #0 screwdriver, locate and remove the two 3mm screws on the top of the fan using a counter-clockwise rotation.

  3. UP! Plus 2 Extrusion Head Fan Replacement: passo 3, immagine 1 di 2 UP! Plus 2 Extrusion Head Fan Replacement: passo 3, immagine 2 di 2
    • Locate the fan connector, a 2-pin JST type, from the extruder board on the top of the extruder assembly and while firmly holding the plastic part of the connector, wiggle out the wire.

    • Gently lift the fan off and away from the module. The fan should easily fall out.

  4. UP! Plus 2 Extrusion Head Fan Replacement, Insert replacement fan: passo 4, immagine 1 di 2 UP! Plus 2 Extrusion Head Fan Replacement, Insert replacement fan: passo 4, immagine 2 di 2
    • Place the replacement fan on the extruder assembly in the right orientation.

    • Connect the cable make sure that it has a solid connection.

    • The fins of the fan should be directed to blow torwards the hot extruder shown in the picture, not away.

    • Secure the fan by screwing the top screws back into place in a clockwise rotation.

    • Finish by putting the plastic top back on.

Conclusione

To reassemble your device, follow these instructions in reverse order.

valerie boyer

Membro da: 10/12/14

508 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 14-31, Maness Fall 2014 Membro di Cal Poly, Team 14-31, Maness Fall 2014

CPSU-MANESS-F14S14G31

4 Membri

5 Guide realizzate

Un commento

I have a problem with my UP PLUS 3D printer and I really need your help. First printer started to stop in the middle of the printing, then got to the point where I wasn’t even able to connect it to my laptop (it didn’t recognize it) and now, when I press Print, before even slicing completes, the software crashes and I have to reopen (basically I can’t print anything as every time I try, same thing happens). The weird part is that sometimes I can adjust the bed, heat up extruder, extract or retract filament from software but the moment I press print, it dies. PLEASE HELP!!!

Nima - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 18

Tutti i Tempi: 838