Aggiusta la tua roba Comunità Store

Trio STEALTH-9 Camera Replacement

Introduzione

This guide should not be too difficult, as there isn't really a need to use any soldering/desoldering tools to take apart anything. You will have to still be careful about some of the cables within the device though.

Cosa ti serve

  1. Trio STEALTH-9 Camera Replacement, Back Cover: passo 1, immagine 1 di 1

    • Remove the two Phillips #00 screws on the side of the tablet.

    Modifica

  2. Trio STEALTH-9 Camera Replacement: passo 2, immagine 1 di 1

    • Take one of the plastic opening tools and wedge it in the middle of the tablet, starting on the USB Port side.

    • Holding the tool in place, take one of the 6 plastic opening picks and slide it across the opening you made with the opening tool.

    Modifica

  3. Trio STEALTH-9 Camera Replacement: passo 3, immagine 1 di 1

    • Continue going around the tablet sides with the plastic pick, being sure that you are maintaining the openings you made with either your hand or the opening tool.

    • You will notice some popping as you go around with the pick. Don't worry, this is completely normal.

    Modifica

  5. Trio STEALTH-9 Camera Replacement: passo 4, immagine 1 di 1

    • Remove the back cover of the tablet to reveal the internals.

    • To replace, pinch each of the ends together until all four sides are closed.

    Modifica

  6. Trio STEALTH-9 Camera Replacement, Camera: passo 5, immagine 1 di 2 Trio STEALTH-9 Camera Replacement, Camera: passo 5, immagine 2 di 2

    • Slowly remove the two pieces of electrical tape holding down the Camera ribbon cable.

    Modifica

  7. Trio STEALTH-9 Camera Replacement: passo 6, immagine 1 di 2 Trio STEALTH-9 Camera Replacement: passo 6, immagine 2 di 2

    • Remove the #00 Screw holding down the Camera mount, then remove the Camera mount.

    Modifica

  8. Trio STEALTH-9 Camera Replacement: passo 7, immagine 1 di 2 Trio STEALTH-9 Camera Replacement: passo 7, immagine 2 di 2

    • Detach the Camera's ribbon cable from the Motherboard using your fingernail or a plastic opening tool.

    • Remove the camera from the frame and replace as needed.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 1 altro collaboratore

[deleted]

Membro da: 01/29/15

415 Reputazione

3 Guide realizzate

Distintivi: 8

+5 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 3

Tutti i Tempi: 137