Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 2 : passo 1, immagine 2 di 2
    • Lay the device face down with the battery facing away from you. Locate the center panel. It will have two vents in it and three screws on the left side.

    • Loosen the three screws that hold the rear access panel on, using your Phillips #1 Screwdriver.

    • The screws will not actually come out from the panel but will be loose and let the panel come off.

    • Lift the left side of the panel to remove it.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • Locate and pull back the two mounting clips on either side of the memory chip.

    • Be sure that when replacing the board, push down gently until the clips snap back in.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 2 : passo 3, immagine 2 di 2
    • Lift RAM circuit board to about a 45 degree angle and pull gently to the right.

Linea Traguardo

Altre 2 persone hanno completato questa guida.

Team

Cal Poly, Team 7-8, Maness Winter 2013 Membro di Cal Poly, Team 7-8, Maness Winter 2013

CPSU-MANESS-W13S7G8

4 Membri

8 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 11

Tutti i Tempi: 613