Parti

Nessuna parte richiesta.

Use tweezers to remove the small rubber covers over the screws on the top and bottom of the laptop case.
  • Use tweezers to remove the small rubber covers over the screws on the top and bottom of the laptop case.

Aggiungi Commento

Use a #1 Phillips screwdriver to remove the 3mm screws located on both sides of the top of the laptop as well as the lower corners.
  • Use a #1 Phillips screwdriver to remove the 3mm screws located on both sides of the top of the laptop as well as the lower corners.

Aggiungi Commento

  • Use a plastic opening tool to separate the front plastic panel from the back side of the top of the laptop.

  • Carefully pull the top away from the back.

Aggiungi Commento

  • Turn the laptop around.

  • Remove the webcam/microphone data cable.

Aggiungi Commento

  • Remove the lower lighting power supply.

  • Remove the signal light power supply and data cable.

Aggiungi Commento

  • Locate and remove the four 2mm #1 Phillips screws around the sidewalls of the display.

  • After removing the last screw, the screen will be very loose, be sure to keep a hand on it to prevent it from damaging the keyboard.

Aggiungi Commento

  • Carefully remove the screen from the side brackets.

  • Remove the LCD ribbon connector from the display.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Brandon Kirklen

Membro da: 11/01/2013

269 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 7-8, Maness Winter 2013 Membro di Cal Poly, Team 7-8, Maness Winter 2013

CPSU-MANESS-W13S7G8

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 547