Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Close the laptop lid and flip it over so that Toshiba logo is facing down.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 6.5 mm Phillips head screws indicated using a Phillips #00 screw driver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the screws are removed, slide the battery pack out of the computer.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Anti-Static Wrist Strap$7.95-
Remove all 6.5 mm Philips head screws on the back cover of the laptop with a Philips #00 screwdriver.
-
Use the plastic opening tool to remove the back cover from the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a black tweezer tool, lift the tab holding the ribbon in place and then gently pull it out.
-
Using the same tweezer tool, again lift the tab holding the wires in place and gently pull them out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the two 3mm Phillips head screws on each fan using the Phillips #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four, 3mm Phillips head screws holding the last piece to the laptop using a Phillips #00 screwdriver.
-
Gently pull the cooling fan with heat sink off the laptop and set aside.
-