Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unlock the right tab by sliding it to the right with your finger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the left tab to the left using your left hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery by placing your finger in the middle groove and lifting up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 13 Phillips #1 10mm screws from the backside of your computer using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #1 6mm screws from the backside of your computer using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 3mm screws from beneath the battery with a Phillips #1 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the corner panel and remove it with your hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four Phillips #1 3mm using a Phillips #1 screwdriver.
-
Unscrew the four 10mm screws around hard drive using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the hard drive case, first pull the black tab to the right.
-
Then pull the black tab up to remove the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic strip above the "F" keys using the spudger by placing the small end of the spudger under the strip and lifting up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #1 3mm screws underneath the plastic strip using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the keyboard up and remove it with your hands.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five Phillips #1 10mm screws underneath the keyboard using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the plastic panel and carefully disconnect the red and white ports.
-
Remove the panel
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop over so the bottom is facing up
-
Then remove the 3mm screw with a #1 screwdriver, located underneath the panel containing the wifi card and RAM
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop back over so the motherboard is facing up
-
Now slide the optical drive out of the computer by gently pulling it to the right
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.