Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unlock the right tab by sliding it to the right with your finger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Hold the left tab to the left using your left hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery by placing your finger in the middle groove and lifting up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 13 Phillips #1 10mm screws from the backside of your computer using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #1 6mm screws from the backside of your computer using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 3mm screws from beneath the battery with a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the corner panel and remove it with your hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four Phillips #1 3mm using a Phillips #1 screwdriver.
-
Unscrew the four 10mm screws around hard drive using a Phillips #1 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the hard drive case, first pull the black tab to the right.
-
Then pull the black tab up to remove the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic strip above the "F" keys using the spudger by placing the small end of the spudger under the strip and lifting up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #1 3mm screws underneath the plastic strip using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the keyboard up and remove it with your hands.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five Phillips #1 10mm screws underneath the keyboard using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the plastic panel and carefully disconnect the red and white ports.
-
Remove the panel
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop over so the bottom is facing up
-
Then remove the 3mm screw with a #1 screwdriver, located underneath the panel containing the wifi card and RAM
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop back over so the motherboard is facing up
-
Now slide the optical drive out of the computer by gently pulling it to the right
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Phillips #1 3mm screws from the fan using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
LIft up on the fan and remove it from the computer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the six 6mm screws from the motherboard with a #1 phillips screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the lone 10mm screw from the motherboard with a phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the motherboard with your hands by carefully lifting up and pulling out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four Phillips #1 6mm single coil pickup screws from the cooling unit and remove the cooling unit.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a flathead screwdriver, undo the lock on the CPU with a half turn in the counterclockwise direction.
-
Remove the CPU by lifting up on the chip.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.
Un commento
Just be vary careful with unplugging any connectors. one false step and you could wind up with some more problems.