Introduzione

Standard Keyboard with 10-key and touchpad with multi-touch control

Turn the laptop off and remove all sources of power.
  • Turn the laptop off and remove all sources of power.

  • Flip the laptop over so that way the bottom is facing towards you.

  • Remove the two 6.6mm Phillips #0 screws from the battery.

Aggiungi Commento

Pull the battery out of the laptop.
  • Pull the battery out of the laptop.

Aggiungi Commento

  • Remove the thirteen 6.6mm Phillips #0 screws on the back of the device.

Aggiungi Commento

  • Use a plastic opening tool to lift and remove the bottom panel.

Aggiungi Commento

  • Remove the six 2.3mm Phillips #0 screws from the motherboard.

  • Use a pair of tweezers to lift up the tab on the ZIF connector and pull out the ribbon cable.

Aggiungi Commento

  • Disconnect the wires from the motherboard.

  • Lift and remove the disk drive.

  • Lift and remove the hard drive.

Aggiungi Commento

  • Lift up the motherboard

  • Use tweezers to carefully peel apart IDE ribbon cables connected from motherboard to keyboard

Aggiungi Commento

  • Use a plastic opening tool to unlatch the keyboard from the device

  • Lift the keyboard off the laptop, careful of the IDE ribbon cable

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Pablo Andrade

Membro da: 14/02/2018

902 Reputazione

7 Guide realizzate

Team

USF Tampa, Team S3-G1, Nance Spring 2018 Membro di USF Tampa, Team S3-G1, Nance Spring 2018

USFT-NANCE-S18S3G1

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 29

Tutti i Tempi: 157