Introduzione

This guide gives instructions on how to remove the disc drive front flap of the Toshiba SD-K740 DVD player.

Parti

Nessuna parte richiesta.

  1. Make sure the DVD player is unplugged before beginning.
    • Make sure the DVD player is unplugged before beginning.

    • Remove the three .303 inch screws from the back panel using a #0 Phillips head screwdriver.

    Aggiungi Commento

  2. Turn the DVD player on its side.
    • Turn the DVD player on its side.

    • Remove the .303 inch screw.

    • Now flip the DVD player onto its other side.

    • Remove the .303 inch screw from this side.

    Aggiungi Commento

    • Flip the DVD player over onto it's front face.

    • Remove the back panel by lifting up and pulling it towards yourself.

    Aggiungi Commento

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Flip the DVD player so its top is sitting on your working surface.

    • Lift and push away each of the two tabs located in the middle of the player.

    • The front panel will not come off during this step, so do not force it.

    Aggiungi Commento

    • Flip the DVD player on its side.

    • Lift and slide forward a single tab on the side.

    • The front panel will not come off during this step, so do not force it.

    Aggiungi Commento

    • Grasp the front panel and pull forward and to your right to remove.

    Aggiungi Commento

    • On back side of front panel very carefully apply pressure to the left hand side of the flap hinge.

    • There is just enough tolerance in the plastic to allow removal, be careful of brittle plastic.

    Aggiungi Commento

    • Once the peg is free from the left restraint, carefully remove the left part of the flap.

    • Carefully remove the right peg from the restraint.

    • Do not pull away from the front panel because the spring is still attached.

    • Do not force the plastic.

    Aggiungi Commento

    • Remove the spring from the end of the right peg by pulling the door away from the spring.

    • Do not pull away from the front panel until the spring has been removed from the flap.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

John Lokker

Membro da: 20/01/2011

319 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 1-16, Amido Winter 2011 Membro di Cal Poly, Team 1-16, Amido Winter 2011

CPSU-AMIDO-W11S1G16

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 1,186