1. Use a bit driver and a Phillips #0 bit to remove the one 5 mm retaining screw.
    • Use a bit driver and a Phillips #0 bit to remove the one 5 mm retaining screw.

    • Lift the panel up and out of the way.

    Aggiungi Commento

  2. The RAM chip is secured by two retaining arms that run parallel with the chip. Gently pull these arms in opposite directions off of the chip.
    • The RAM chip is secured by two retaining arms that run parallel with the chip. Gently pull these arms in opposite directions off of the chip.

    • After the retainer arms are free, push the chip towards the top of the netbook. This will free the chip for removal.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Push the replacement RAM into the original position.

    • Reattach both securing arms onto the sides of the RAM chip.

    Aggiungi Commento

    • Place the panel back into the securing slots and let it rest in its original position.

    • With the bit driver and Phillips #0 bit, secure the panel down with one screw.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Membro da: 18/10/2013

943 Reputazione

9 Guide realizzate

Team

Clemson, Team 14-2, Benson Fall 2013 Membro di Clemson, Team 14-2, Benson Fall 2013

CLEM-BENSON-F13S14G2

3 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 6

Tutti i Tempi: 288