Parti

Nessuna parte richiesta.

Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
  • Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

Aggiungi Commento

With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
  • With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

  • The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

Aggiungi Commento

  • If needed, use the flathead screwdriver to gently pry the panel from the phone.

  • Using your fingers, lift the panel from the device.

Aggiungi Commento

  • Use your fingers to gently detach the ribbon wire from the logic board.

Aggiungi Commento

  • Use the flathead screwdriver to pry the logic board and keypad from the device.

Aggiungi Commento

  • Use your thumb to peel the keypad from the device.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Christopher

Membro da: 22/04/2010

90 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 16-6, Maness Spring 2010 Membro di Cal Poly, Team 16-6, Maness Spring 2010

CPSU-MANESS-S10S16G6

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 2,503