Introduzione

Use this guide to replace the Toshiba A1304T camera.

Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
  • Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

Aggiungi Commento

With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
  • With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

  • The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

Aggiungi Commento

  • If needed, use the flathead screwdriver to gently pry the panel from the phone.

  • Using your fingers, lift the panel from the device.

Aggiungi Commento

  • Using a small Phillips screwdriver, remove the two black screws from the positions indicated.

  • Gently pull the silver plate from the phone using your fingers.

Aggiungi Commento

  • Using the head of a flathead screwdriver, flip the white segment of the socket that the camera's ribbon-wire runs into so that it is orientated vertically.

  • Gently lift the camera from its cavity and pull it away from the socket using your thumb and forefinger.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Christopher

Membro da: 22/04/2010

90 Reputazione

16 Guide realizzate

Team

Cal Poly, Team 16-6, Maness Spring 2010 Membro di Cal Poly, Team 16-6, Maness Spring 2010

CPSU-MANESS-S10S16G6

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,936