1. Peel back the sticker, using the tweezers on the bottom of the device to reveal the two screws.
    • Peel back the sticker, using the tweezers on the bottom of the device to reveal the two screws.

    Aggiungi Commento

  2. Unscrew the two T5 screws using the T5 Torx Screwdriver.
    • Unscrew the two T5 screws using the T5 Torx Screwdriver.

    Aggiungi Commento

    • Insert the flat head screwdriver into the edge of the device. Using it as a lever, carefully pry the face-plate up.

    Aggiungi Commento

    • Carefully grab the ribbon cable with two fingers and pull the yellow ribbon cable upwards away from the motherboard.

    Aggiungi Commento

  3. Diffondere allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondere allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Remove the screen from of the face-plate.

    Aggiungi Commento

    • Insert the new screen into the face-plate.

    Aggiungi Commento

    • Reattach the yellow ribbon cable to the motherboard.

    Aggiungi Commento

    • Using two hands, hold both ends of the device and snap the two plates together.

    Aggiungi Commento

    • Re-insert the two T5 screws and tighten.

    Aggiungi Commento

    • Re-apply the label edges back down to cover the screws.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Mike Sollars

Membro da: 11/07/2013

471 Reputazione

3 Guide realizzate

Team

WRI115, Team 1-1, Ruszkiewicz Spring 2013 Membro di WRI115, Team 1-1, Ruszkiewicz Spring 2013

WRI115-RUSZKIEWICZ-S13S1G1

4 Membri

3 Guide realizzate

Hi! Thanks for doing this. How do I release the yellow cable from the board?

Shaun B - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 9

Tutti i Tempi: 1,364