1. Power down the TiVo and detach the power cable from the rear of the unit.
    • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

  2. Remove the five T10 screws from the rear of the case using the Torx screwdriver.
    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

  3. Lift up and pull back the outer casing towards the rear of the unit. Lift up and pull back the outer casing towards the rear of the unit.
    • Lift up and pull back the outer casing towards the rear of the unit.

  4. On the rear of the device, remove the right screw with a T10 Torx Screwdriver.
    • On the rear of the device, remove the right screw with a T10 Torx Screwdriver.

    • Unscrew the two black screws on the left with a T8 Torx Screwdriver.

  5. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  6. Disconnect the white ribbon cable from the motherboard.
    • Disconnect the white ribbon cable from the motherboard.

    • The black base where the cable is connected is not part of the cable. Do not lift up on it!

  7. Remove fan power connector.
    • Remove fan power connector.

  8. Disconnect the hard drive data cable.
    • Disconnect the hard drive data cable.

    • Use extreme caution when unplugging the connector and do not disconnect the data cable by pulling on the cable itself.

  9. Disconnect the connector cable that goes to the lights on the front of the device.
    • Disconnect the connector cable that goes to the lights on the front of the device.

  10. Unscrew the four screws on the motherboard with a T10 screwdriver.
    • Unscrew the four screws on the motherboard with a T10 screwdriver.

  11. Use a pair of needle-nose pliers to make the two tabs parallel with the open slots. It is recommended that you do not bend these back after putting unit back together as they may break after repeated use. It is recommended that you do not bend these back after putting unit back together as they may break after repeated use.
    • Use a pair of needle-nose pliers to make the two tabs parallel with the open slots.

    • It is recommended that you do not bend these back after putting unit back together as they may break after repeated use.

  12. Pull the motherboard out towards the front of the TiVo unit, then pull up to remove it.
    • Pull the motherboard out towards the front of the TiVo unit, then pull up to remove it.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 33-79, Johann Spring 2010 Membro di Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 4,202