Salta al contenuto principale

Introduzione

Follow this guide to remove and replace the printing unit in the TI-5130 electronic calculator.

  1. Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver. Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.
    • Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.

  2. Flip the calculator back over and remove the top cover.
    • Flip the calculator back over and remove the top cover.

  3. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  4. Disconnect the printing unit from the motherboard by pulling up on the connector – located in the bottom left of the motherboard.
    • Disconnect the printing unit from the motherboard by pulling up on the connector – located in the bottom left of the motherboard.

  5. Remove the ink cartridge by pushing the tab back then lifting it out to gain access to the screw that holds the printer in place.
    • Remove the ink cartridge by pushing the tab back then lifting it out to gain access to the screw that holds the printer in place.

  6. Using a PH1 screwdriver remove the 10mm screw that holds down the printer unit. Remove the printer unit by lifting it up.
    • Using a PH1 screwdriver remove the 10mm screw that holds down the printer unit.

    • Remove the printer unit by lifting it up.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

wehre did you buy the replacement printer

Tino ullrich - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,064