Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 6 Phillips #1 screws from the back panel.
-
Remove the back panel.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Make sure the machine is turned off and unplugged.
-
Set your voltmeter in continuity mode and place the leads on the two 90 degree prongs on the boiler's heating element.
-
If the voltmeter shows 0, or "open", then there is an issue with the heating element's continuity and it needs to be replaced.
-
If given a reading, then your heating element is fine.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
In the water reservoir, place mixture of de-calcifying agent and water as directed on the product label.
-
Place a cup, to catch fluid, underneath the portafilter.
-
Run Barista, as if making coffee, for the amount of time directed by the de-calcifying product.
-
See the links section of the device page for further directions.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.
Team
Cal Poly, Team 4-42, Regan Winter 2011 Membro di Cal Poly, Team 4-42, Regan Winter 2011
CPSU-REGAN-W11S4G42
4 Membri
5 Guide realizzate
6 Commenti
I did this a few months ago and the boiler was full of rusty gunk. This guide sure did help me out.
the same here - it was disgusting... was afraid to have damaged it while cleaning it. tested it yesterday already... just going through all the steps to validate function of the units.
hi ! we have Starbucks Barisa Milano. some how it didnt want switch on! my husband wanted to have a look but we cant open. do you gave any guidence?
I feel the temperature of the espressos i’m making is not hot enough. How do i raise the thermostat to activate the Ready light at a higher temp?
