Introduzione

Replace an aging power cord on the TRS-80 Color Computer.

Parti

Nessuna parte richiesta.

Flip the computer over.
  • Flip the computer over.

  • Remove the two 24.1mm Phillips screws near the front of the case.

  • Remove the five 33.0 mm Phillips screws towards the back of the case.

Aggiungi Commento

Carefully flip the computer right side up. Lift off the top half of the case.
  • Carefully flip the computer right side up.

  • Lift off the top half of the case.

Aggiungi Commento

Near the motherboard, gently pull the keyboard ribbon cable until it becomes free. Lift the keyboard out of the case.
  • Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.

  • Lift the keyboard out of the case.

Aggiungi Commento

Remove the nine 15.24 mm Phillips screws securing the motherboard in place. When removing the spring door, make sure to keep the door closed. When removing the spring door, make sure to keep the door closed.
  • Remove the nine 15.24 mm Phillips screws securing the motherboard in place.

  • When removing the spring door, make sure to keep the door closed.

Aggiungi Commento

Remove the 5 jumper cables from the motherboard. Once the jumper cables lift the motherboard up gently; it should lift out easily. Once the jumper cables lift the motherboard up gently; it should lift out easily.
  • Remove the 5 jumper cables from the motherboard.

  • Once the jumper cables lift the motherboard up gently; it should lift out easily.

Aggiungi Commento

Remove the two 1.6 inch screws securing the transformer. Remove the two 1.6 inch screws securing the transformer.
  • Remove the two 1.6 inch screws securing the transformer.

Aggiungi Commento

Remove the power cord's three leads from the transformer.
  • Remove the power cord's three leads from the transformer.

  • Note the orientation and color of the three leads. Make sure to replace these exactely as they were.

Aggiungi Commento

Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out. Remove the entire length of cord from the case and replace with a new one.
  • Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out.

  • Remove the entire length of cord from the case and replace with a new one.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Team

Cal Poly, Team 11-24, Maness Winter 2011 Membro di Cal Poly, Team 11-24, Maness Winter 2011

CPSU-MANESS-W11S11G24

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 5

Tutti i Tempi: 1,709