Introduzione

Sometimes rough play can cause the wheel to break or not spin anymore. This guide will show you how to remove the wheel.

  1. lay the Hatchimal on its side.
    • lay the Hatchimal on its side.

  2. Using the plastic opening tool, push in on the purple clip.
    • Using the plastic opening tool, push in on the purple clip.

    • Pull the wing off of the hatchimal.

    • The wing should come off with little resistance.

    • Cut the fur retaining zip-tie with a pair of scissors.

    • Lift the fur up until it can't go further.

    • Use the spudger tool to push up on the black clip to free it.

    • Pull the clip out.

    • Lift fur up to reveal the next set of clips.

    • Insert a spudger to push up on the black clip to free it.

    • Pull out the clip.

    • Lift the fur up and over the Hatchimals Head.

    • Remove the six 12mm Phillips #00 screws from then body.

    • Pull the casing apart.

    • Remove the yellow speaker cable.

    • Remove the three 7mm Phillips #00 screws from the head.

    • Remove the wheel base and the circuit board carefully not to damage the spring.

    • Push the six black fur clips out using the spudger.

    • Remove the fur completely.

    • Lift up and remove the light blue plastic casing.

    • Remove the six 7mm Phillips #00 screws.

    • Remove the purple plastic casing. It should come off with little resistance.

    • Remove the wheel.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Humaid Alhajri

Membro da: 14/02/2018

97 Reputazione

1 Guida realizzata

Team

USF Tampa, Team S1-G5, Nance Spring 2018 Membro di USF Tampa, Team S1-G5, Nance Spring 2018

USFT-NANCE-S18S1G5

3 Membri

5 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 62

Tutti i Tempi: 176