Speaker

Flip over the Nokia and locate the back cover. Press your thumb on the back cover and slide it off the phone.

Remove the battery from the phone by hand.

With the phone closed, run a plastic opening tool along the seam of the top half of the phone.

Make sure to disconnect each of the five clips before proceeding (2 on each side, 1 on top).

Using the T6 Torx Screwdriver, remove the four 3.16mm screws from the front panel.

Note that the fourth screw is under a fold in the ribbon cable.

Starting in the lower right corner, slowly start to lift the tape that is holding the front LCD and cables down.

Be careful around the two ribbon cables attached to the tape. These cables are fragile.

Lift the tape from the board.

Using a plastic opening tool, lift the ribbon cable connection below the front LCD.

Using a plastic opening tool, slowly pry up the LCD display from the bottom, releasing it from the glue holding it to the board.

Locate the ribbon cable connection in the upper right hand corner of the board.

Using a plastic opening tool, lift off the cable from the board.

Using a plastic opening tool, slowly work the board off the mounts holding it to the frame.

Flip the board over to reveal the main display.

Locate the ribbon cable for the main display on the bottom of the board.

Slowly lift off the ribbon connector from its housing using a plastic opening tool.

Slowly wedge the plastic opening tool under the bottom of the main display.

Separate the display from the glue lifting it off the board.

Using a case opening tool, gently pry the speaker in the bottom corner from the glue from right to left until it pops out.