Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Scalda i bordi della cover con una pistola ad aria calda, una piastra o un iOpener.
-
-
-
Usa la punta piatta di uno spudger per disconnettere la batteria. Esegui questo passaggio con cautela.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four screws on the corners of the back frame using the JIS #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the plastic opening tool under the back frame. Move the plastic opening tool around the entire frame to separate it from the adhesive.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the spudger underneath the external speaker. Pull up on the external speaker using the spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the square rubber gasket from the camera using the plastic spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the black plastic corner still holding in the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry up on the four sides of the motherboard using the plastic spudger til it separates from the base of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry up on the earpiece from the left side to remove it.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.