Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge your finger under the bottom ridge of the SD card insert.
-
Pull outwards with your fingers to remove the SD card from the left side of device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a hair dryer to heat each corner of the phone.
-
Alternate heating each corner for a minute to loosen the adhesive binding the back cover to the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press a suction cup on a heated corner of the device.
-
Hold the phone down and gently lift the suction cup to create a small gap.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Plastic Cards$2.99-
Insert your iFixit Opening Tool in the small gap between your phone and the back cover.
-
Lift up on the iFixit Opening Tool and insert your plastic card in the small gap between your phone and the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide your plastic card along the side of your phone to loosen the adhesive.
-
Move the card along the sides of the phone to lift all of the corners.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the back cover by lifting up the sides of the phone with your hand.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 4mm T5 screws connecting the speaker to your phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert your iFixit Opening Tool underneath the speaker and gently lift up.
-
Once the speaker is slightly lifted, use your hands to remove the piece from the device.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.