Sony Xperia XA1 Ultra Loudspeaker Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

This guide will show you how to remove the loudspeaker from your Sony Xperia XA1 Ultra. The loudspeaker needs to be replaced if sound is no longer emitted from your phone. A heat gun or hairdryer is needed to open the back panel, which can become hot and potentially damage the phone. In addition, a T5 screwdriver is needed to remove screws, and a spudger is used to lift and remove components of the phone.

Cosa ti serve

Passo 1 Back Assembly

Sony Xperia XA1 Ultra Loudspeaker Replacement, Back Assembly: passo 1, immagine 1 di 2

Sony Xperia XA1 Ultra Loudspeaker Replacement, Back Assembly: passo 1, immagine 2 di 2

Wedge your finger under the bottom ridge of the SD card insert.
Pull outwards with your fingers to remove the SD card from the left side of device.

Traduci

Passo 2

Use a hair dryer to heat each corner of the phone.
Alternate heating each corner for a minute to loosen the adhesive binding the back cover to the phone.
Don't heat one area for too long; the phone may get damaged from overheating.

Traduci

Passo 3

Press a suction cup on a heated corner of the device.
Hold the phone down and gently lift the suction cup to create a small gap.
You may hear crunching or popping sounds when you lift up the back cover.

Traduci

Passo 4

Attrezzo utilizzato in questo passaggio:

Plastic Cards

$2.99

Compra

Insert your iFixit Opening Tool in the small gap between your phone and the back cover.
Lift up on the iFixit Opening Tool and insert your plastic card in the small gap between your phone and the back cover.

Traduci

Passo 5

Slide your plastic card along the side of your phone to loosen the adhesive.
Move the card along the sides of the phone to lift all of the corners.

Traduci

Passo 6

Lift up the back cover by lifting up the sides of the phone with your hand.
Apply a new strip of adhesive for reassembly.

Traduci

Passo 7 Loudspeaker

Sony Xperia XA1 Ultra Loudspeaker Replacement, Loudspeaker: passo 7, immagine 1 di 1

Remove the five 4mm T5 screws connecting the speaker to your phone.

Traduci

Passo 8

Insert your iFixit Opening Tool underneath the speaker and gently lift up.
Once the speaker is slightly lifted, use your hands to remove the piece from the device.

Traduci