Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Apply heat on the back surface of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Stick the small suction cup on the bottom half of the back surface of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the bottom of the device facing you, lift up on the suction cup handle.
-
Use the plastic opening tool around all sides to pry off the back cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the back of the phone case away from the device.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five black 4mm screws with a Phillips #00 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry up the black camera case with the plastic opening tool and then remove the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of the spudger to peel up the copper tab to the right of the back camera.
-
Peel back the tab past the connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry up the camera's connector to the motherboard with the nylon spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of the nylon spudger to lift the camera out of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Finish removing the front camera by lifting it gently with your fingers.
-