Sony Xperia M4 Aqua Rear Camera Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

This is the step-by-step guide for replacing the Sony Xperia M4 Aqua rear camera.

Cosa ti serve

Passo 1 Back Cover

Sony Xperia M4 Aqua Rear Camera Replacement, Back Cover: passo 1, immagine 1 di 1

Place the phone face-down, and use a heat gun or hair dryer to evenly heat the back surface until to soften the adhesive.

Traduci

Passo 2

Attach a suction cup to the back of the M4 Aqua by carefully pushing down on it near the top of the phone.

Traduci

Passo 3

While Pulling on the suction cup, slide a thin plastic spacer (guitar picks work well) between the back cover and the phone. Slide it around the edges to break the adhesive seal. Be careful, but don't be afraid to use some force. You should hear a sticky breaking sound.

Traduci

Passo 4

Remove the back cover by pulling it from the chassis. it is flexible and can be bent, be careful.

Traduci

Passo 5 Battery

Sony Xperia M4 Aqua Rear Camera Replacement, Battery: passo 5, immagine 1 di 1

Remove copper plated tape and any other securing adhesive with a nylon spudger. Remove carefully, as it has the potential or tear if too much force is used.

Traduci

Passo 6

Unhook the battery connector carefully. It is possible to damage the battery if too much force is used.

Traduci

Passo 7

Pry the battery from the phone with the nylon spudger. There is a small amount of adhesive underneath the battery, so a bit of force is required. The battery is malleable, so it is possible to dent the battery if too much force is applied in one spot.

Traduci

Passo 8

Remove the battery once all of the adhesive is broken, and the connector is unplugged.

Traduci

Passo 9 Rear Camera

Sony Xperia M4 Aqua Rear Camera Replacement, Rear Camera: passo 9, immagine 1 di 1

Remove the four hex head 3mm screws at each corner of the motherboard with a screwdriver.

Traduci

Passo 10

Remove three pieces of the securing bracket using tweezers

Traduci

This step is wrong. It’s actually two security brackets, not three, as long as you don’t break the one on the left/upper side. If you do it like it’s shown here you will break this part. The correct way to do this is remove the bracket on the right side, then remove the board with the other bracket still attached. Watch this video to get an idea: https://youtu.be/9o1DGKT76eo (interesting part starting at 1:50).

Willkeinkonto - 31 gen 2022 Replica