Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Sony XAV-AX100 Display Replacement

Cosa ti serve

  1. Sony XAV-AX100 Display Replacement, USB Cable: passo 1, immagine 1 di 3 Sony XAV-AX100 Display Replacement, USB Cable: passo 1, immagine 2 di 3 Sony XAV-AX100 Display Replacement, USB Cable: passo 1, immagine 3 di 3
    • Place the device on a flat surface, upside down, so the bottom of the screen would be facing upwards.

    • Remove the ten 3.5mm Phillips #0 screws from the back plate.

  2. Sony XAV-AX100 Display Replacement: passo 2, immagine 1 di 2 Sony XAV-AX100 Display Replacement: passo 2, immagine 2 di 2
    • Use a plastic opening tool to remove the back plate.

    • Don't remove completely as there will still be cables connected.

  3. Sony XAV-AX100 Display Replacement: passo 3, immagine 1 di 1
    • Disconnect the USB cable from the display board.

  4. Sony XAV-AX100 Display Replacement: passo 4, immagine 1 di 1
    • Adjust the rubber holders that are keeping the USB cable still on the motherboard, so you can remove the cable entirely from the inner compartment.

    • The rubber holders are extremely sensitive to any applied force. Therefore, be careful while turning them around.

  5. Sony XAV-AX100 Display Replacement: passo 5, immagine 1 di 3 Sony XAV-AX100 Display Replacement: passo 5, immagine 2 di 3 Sony XAV-AX100 Display Replacement: passo 5, immagine 3 di 3
    • Remove the 3.5mm Phillip #0 screw that secures the USB cable to the back panel.

    • Pull the USB cable off of the back plate.

  6. Sony XAV-AX100 Display Replacement, Motherboard: passo 6, immagine 1 di 2 Sony XAV-AX100 Display Replacement, Motherboard: passo 6, immagine 2 di 2
    • Disconnect the display power cable from the motherboard.

    • Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

  7. Sony XAV-AX100 Display Replacement: passo 7, immagine 1 di 3 Sony XAV-AX100 Display Replacement: passo 7, immagine 2 di 3 Sony XAV-AX100 Display Replacement: passo 7, immagine 3 di 3
    • Unscrew the four 3.5mm Phillips #0 screws from the motherboard.

    • Use a spudger to gently lift the motherboard up and out of the radio.

  8. Sony XAV-AX100 Display Replacement, Display: passo 8, immagine 1 di 1
    • Remove the four 3.5mm Phillips #0 screws from the sides of the display.

  9. Sony XAV-AX100 Display Replacement: passo 9, immagine 1 di 2 Sony XAV-AX100 Display Replacement: passo 9, immagine 2 di 2
    • Remove two 3.5mm Phillips #0 screws from the back of the head unit.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Team

USF Tampa, Team S1-G5, Cagle Spring 2018 Membro di USF Tampa, Team S1-G5, Cagle Spring 2018

USFT-CAGLE-S18S1G5

2 Membri

5 Guide realizzate

3 Commenti

Where do you get a replacement screen?

I need one for a xav 3005 db

Morten Hjorth-Johansen - Replica

Thank you very much for this great write up.

However after having performed it, if all you are doing is replacing the screen, then steps 1, 4, 5 and 7 are actually completely unnecessary . There is no need to remove the back panel or the motherboard.

but thank you nonetheless for having shown the way.

Robert Edwards - Replica

I need to get a replacement screen for a Sony xav 1500 any idea of a cheap place?

Abelardo M. - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 60

Tutti i Tempi: 4,734