Salta al contenuto principale

Introduzione

If your device no longer takes a charge, replacing the battery may breathe new life into the tablet.

Ricambi

Nessuna parte specificata.

  1. Begin by opening the HDMI/USB port cover on the left edge.
    • Begin by opening the HDMI/USB port cover on the left edge.

    • Remove the three #000 headed, 3 mm long screws located underneath the port cover.

  2. Locate and open the Micro SD slot on the top side of the device.
    • Locate and open the Micro SD slot on the top side of the device.

    • Remove the two screws located beneath the cover.

  3. Attach the suction cup to the top right area of the screen. Pull to separate the screen from the rest of the device.
    • Attach the suction cup to the top right area of the screen.

    • Pull to separate the screen from the rest of the device.

    • Be aware of the front camera cable that is still connected to the rest of the device.

    • Detach the display ribbon cable.

  4. Disconnect the battery from the motherboard by pulling out the cable below the fan.
    • Disconnect the battery from the motherboard by pulling out the cable below the fan.

  5. Remove the seven 3 mm Phillips #000 screws that hold the battery in place.
    • Remove the seven 3 mm Phillips #000 screws that hold the battery in place.

    • Carefully remove the battery from the back assembly.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Alexander Bridges

Membro da: 16/09/2015

1.217 Reputazione

7 Guide realizzate

Team

IUPUI, Team 1-2, Harley Fall 2015 Membro di IUPUI, Team 1-2, Harley Fall 2015

IUPUI-HARLEY-F15S1G2

4 Membri

20 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 45

Tutti i Tempi: 5,117