Sony Vaio PCG-981L Floppy Drive Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

If for any reason the floppy drive isn't working, the simplest solution is to replace the entire drive. But, if you're not able to aquire a new drive you may be able at least find the source of the failure through disassebling the drive.

Cosa ti serve

Passo 1 Floppy Drive

Sony Vaio PCG-981L Floppy Drive Replacement, Floppy Drive: passo 1, immagine 1 di 1

Turn the copmuter over so that its underside is facing up. Then slide the blue floppy drive release button down and pull the floppy drive out of the laptop.

Traduci

Passo 2

Completely remove and isolate the floppy drive from the laptop.

Traduci

Passo 3

There are two screws on each side (total of four screws) of the floppy drive. Remove these screws.

Traduci

Passo 4

Once you have removed the screws, you can remove the floppy drive core from its casing as shown.

Traduci

Passo 5

After you have removed the floppy drive core from its casing, unscrew these five screws shown.

Traduci

Passo 6

Remove the two screws holding part of the floppy processinng unit.

Traduci

Passo 7

Now that the screws are removed, you can remove the entire processing unit of the floppy drive.

Traduci

Passo 8

Here is an isolated image of the core hardware of the floppy drive. Here is where the floppy "magic" happens. Check for any connection failures or shortages. You may need to re solder some of the connections.

Traduci