Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop over and orient it as shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery by pinching the two lock tabs towards the center.
-
Next, lift up on the battery to remove it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #00 screwdriver, remove the twenty-two 5.6 mm screws from the back of the laptop.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now, remove the small covers from the back of the case.
-
Using a Phillips #00 screwdriver, unscrew the three 5.6 mm screws from the covers (one screw on the RAM cover [middle] and two screws on the Hard Drive cover [bottom right]).
-
Then, lift up on and remove these covers as shown in the third image.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the hard drive.
-
Using a Phillips #00 screwdriver, unscrew the two remaining 4.9 mm screws holding the hard drive into place.
-
Next, lift up and pull outwards to release the hard drive from its socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, grasp the black tab and lightly pull up on the ribbon cable to detach it from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After proper removal of all necessary screws, gently lift up on the back case to remove it.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.