Parti

Nessuna parte richiesta.

  1. Flip the computer so that the bottom is facing up.
    • Flip the computer so that the bottom is facing up.

    • Look to the long edge where the computer screen is hinged and find the "release slide". It is located at the top left corner of the square indent.

    Aggiungi Commento

  2. Use your finger to slide the release to the left.
    • Use your finger to slide the release to the left.

    Aggiungi Commento

    • While holding the release slide with one hand, use your opposite hand to pull the battery from its slot by gently shaking the battery left and right to help slide it out.

    Aggiungi Commento

    • Take out the screw in the center of the computer.

    Aggiungi Commento

    • Flip the computer right side up.

    • Open screen so that keyboard is visible.

    Aggiungi Commento

    • Use a plastic opening tool to gently lift the keyboard at a corner.

    • Make sure you get below the keyboard itself and not just the keys.

    • Slide the tool around the perimeter of the keyboard and it will start to lift.

    Aggiungi Commento

    • Do not pull the keyboard away from the computer. There is a ribbon cord attaching the keyboard to the computer.

    • Once the keyboard has been lifted at a few edges, lift the keyboard with both hands.

    Aggiungi Commento

    • Locate the ribbon cord behind the keyboard.

    • Locate a brown clamp attaching the keyboard to the computer.

    • Use a plastic opening tool to lift the clamp and release the cable.

    • Now the keyboard can be pulled away entirely.

    Aggiungi Commento

    • Take out the screw under the keyboard.

    Aggiungi Commento

    • Flip computer over and remove the 6 screws.

    Aggiungi Commento

    • Flip computer over again and unclip the plastic cover.

    • Do not be afraid to be rough, since the cover is hard to remove.

    • Be sure to remove the case slowly and unclip any ribbon cords that are attached.

    Aggiungi Commento

    • Locate the hard drive disk. The hard drive disk will be covered by a shiny lid.

    • Unscrew the lid with a #00 Phillips Head Screwdriver.

    • There are 3 screws holding it in.

    • Grab the lid by one corner and pull off the lid.

    Aggiungi Commento

    • Find the brown clip attached to the hard disk drive on the side facing the optical disk drive.

    • Carefully pull out the brown clip with your fingers.

    Aggiungi Commento

    • Hold the hard disk drive on the side where the brown clip was attached and lift it upwards to pull it out.

    Aggiungi Commento

    • Remove the 3 indicated screws.

    • There are two small scews arounds the edge and one is on top of the optical drive.

    Aggiungi Commento

    • Remove the optical drive from resting positions.

    • Gently remove cord.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Luke Thornley

Membro da: 03/04/2012

87 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 5-3, Forte Spring 2012 Membro di Cal Poly, Team 5-3, Forte Spring 2012

CPSU-FORTE-S12S5G3

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,273