Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
On the back of the camera beneath the viewfinder, locate the battery pack.
-
Press the small button.
-
Slide the switch forward.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a #00 Phillips screwdriver, remove the six 4.5 mm screws from the camera's bottom.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 4.5 mm screws beneath the battery.
-
Remove the 2.9 mm screw from the right corner.
-
Remove the two 4.5 mm screws from the battery's right wall.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4.5 mm screw under the output flap on the front of the camera below the lens.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 4.5 mm screws at the top of the camera.
-
Remove the 4.5 mm screw from the disk side of the camera (next to the lens).
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Extend the gray viewfinder, then gently remove the black plastic casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 2.9 mm screws under the black plastic casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently pull apart the outer silver case and screen.
-
Remove the copper wire strip to detach the case from the camera.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.