Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Sony Ericsson s710a Main Interface Buttons Replacement

Cosa ti serve

  1. Sony Ericsson s710a Main Interface Buttons Replacement, Battery: passo 1, immagine 1 di 1
    • Remove the back cover by sliding it off.

  2. Sony Ericsson s710a Main Interface Buttons Replacement: passo 2, immagine 1 di 1
    • Pull the battery out using your finger.

  3. Sony Ericsson s710a Main Interface Buttons Replacement: passo 3, immagine 1 di 1
    • The battery can now be replaced.

    • The battery is a 780 mAh rechargeable Lithium Ion battery.

  4. Sony Ericsson s710a Main Interface Buttons Replacement, LCD Screen: passo 4, immagine 1 di 1
    • Remove the four 6 mm screws from beneath the battery using a Phillips #00 screwdriver.

  5. Sony Ericsson s710a Main Interface Buttons Replacement: passo 5, immagine 1 di 1
    • Remove the microphone cover using the iFixit opening tool.

  6. Sony Ericsson s710a Main Interface Buttons Replacement: passo 6, immagine 1 di 1
    • Remove the two 6 mm screws from the front of the phone beneath the microphone cover using a Phillips #00 screwdriver.

  7. Sony Ericsson s710a Main Interface Buttons Replacement: passo 7, immagine 1 di 1
    • Remove the black plastic piece on the side.

    • This will allow for easier access while prying the motherboard.

  8. Sony Ericsson s710a Main Interface Buttons Replacement: passo 8, immagine 1 di 1
    • Use the iFixit opening tool to loosen the motherboard from the phone.

  9. Sony Ericsson s710a Main Interface Buttons Replacement: passo 9, immagine 1 di 1
    • Lift the motherboard out with your fingers.

    • Pull slowly. This will require some force.

  10. Sony Ericsson s710a Main Interface Buttons Replacement: passo 10, immagine 1 di 1
    • Remove the two cable connectors using the iFixit opening tool.

    • Mark the orientation and port of each cable before detaching them. The connectors are symmetrical, so this is essential for reassembly.

  11. Sony Ericsson s710a Main Interface Buttons Replacement: passo 11, immagine 1 di 1
    • On the rotational assembly remove the following screws:

    • Four 3 mm screws

    • Two 2.3 mm screws

    • Lift the rotational assembly off of the phone to allow access to the other half of the device.

  12. Sony Ericsson s710a Main Interface Buttons Replacement: passo 12, immagine 1 di 1
    • Detach the cable connectors on the other end of the cables using a plastic opening tool.

    • Record the orientation and location of each connector for reassembly.

  13. Sony Ericsson s710a Main Interface Buttons Replacement: passo 13, immagine 1 di 1
    • Remove the plastic cover on the back of the phone using an iFixit opening tool.

    • Remove the four 6 mm screws using a Phillips #00 screwdriver.

  14. Sony Ericsson s710a Main Interface Buttons Replacement: passo 14, immagine 1 di 1
    • Pry the screen assembly from the main case using the iFixit opening tool.

  15. Sony Ericsson s710a Main Interface Buttons Replacement: passo 15, immagine 1 di 1
    • With the face plate and LCD screen exposed, replace the existing LCD screen with a new LCD screen.

    • Be sure to test and make sure the detachable connections are arranged correctly.

  16. Sony Ericsson s710a Main Interface Buttons Replacement, Main Interface Buttons: passo 16, immagine 1 di 1
    • Remove the button and pad assembly as shown.

    • If desired, these items can now be cleaned or replaced.

Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 953