Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Sony Ericsson Xperia Play Digitizer Replacement

Cosa ti serve

  1. Sony Ericsson Xperia Play Digitizer Replacement, Digitizer: passo 1, immagine 1 di 1
    • Remove the 6 silver torx screws marked in red

  2. Sony Ericsson Xperia Play Digitizer Replacement: passo 2, immagine 1 di 1
    • Remove the 7 black torx screws marked in yellow.

  3. Sony Ericsson Xperia Play Digitizer Replacement: passo 3, immagine 1 di 1
    • Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.

  4. Sony Ericsson Xperia Play Digitizer Replacement: passo 4, immagine 1 di 1
    • Remove the plastic housing revealing the motherboard

    • Remove the two Phillips screws.

  5. Sony Ericsson Xperia Play Digitizer Replacement: passo 5, immagine 1 di 1
    • Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees

  6. Sony Ericsson Xperia Play Digitizer Replacement: passo 6, immagine 1 di 1
    • Slide the phone to the open position

  7. Sony Ericsson Xperia Play Digitizer Replacement: passo 7, immagine 1 di 1
    • Remove the display connector marked in orange using a plastic spudger to pry it upwards

    • Remove the connector for the front buttons by prising the retaining clip to 90 degrees

  8. Sony Ericsson Xperia Play Digitizer Replacement: passo 8, immagine 1 di 1
    • Remove motherboard

  9. Sony Ericsson Xperia Play Digitizer Replacement: passo 9, immagine 1 di 1
    • Remove the buttons from the phone

  10. Sony Ericsson Xperia Play Digitizer Replacement: passo 10, immagine 1 di 1
    • Remove the three Phillips screws.

  11. Sony Ericsson Xperia Play Digitizer Replacement: passo 11, immagine 1 di 1
    • Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw

    • Disconnect the digitizer cable

  12. Sony Ericsson Xperia Play Digitizer Replacement: passo 12, immagine 1 di 1
    • Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass

    • Using a heat gun heat around the edges of the glass to soften the glue, and use your prying tool between the glass and the frame to take the glass off.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 16 persone hanno completato questa guida.

Kris James

Membro da: 01/27/12

603 Reputazione

1 Guida realizzata

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 17

Tutti i Tempi: 31,324