Introduzione

This guide shows how to replace the lens assembly that may not be working properly.

  1. Slide the gray switch from lock to open position.
    • Slide the gray switch from lock to open position.

    Aggiungi Commento

  2. Pull down on the blue tab to release the battery.
    • Pull down on the blue tab to release the battery.

    Aggiungi Commento

    • Use a PH00 screwdriver to remove the five 3.5 mm screws.

    • Use a PH00 screwdriver to remove the two 2.5 mm screws.

    Aggiungi Commento

  3. Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK al checkout
    Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK
    • Pry apart the case gently using a plastic opening tool.

    Aggiungi Commento

    • Pry back the panel to the right of the screen using a plastic opening tool.

    Aggiungi Commento

    • Working on the left side of the screen, pry the metal panel off from the motherboard housing using a plastic opening tool.

    Aggiungi Commento

    • Pull out the ZIF cable from the motherboard.

    • When removing the ZIF cable, pull it straight out to avoid damaging the cable.

    Aggiungi Commento

    • Unpin the ZIF cable by lifting the cable towards the top of the camera while pulling up towards yourself.

    • Pull the ZIF cable out.

    Aggiungi Commento

    • Lift the lens out of the case.

    • Pull out the ZIF cable.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Kate Glazer

Membro da: 20/03/2018

579 Reputazione

5 Guide realizzate

Team

IUPUI, Team S6-G3, Baechle Spring 2018 Membro di IUPUI, Team S6-G3, Baechle Spring 2018

IUPUI-BAECHLE-S18S6G3

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 8

Tutti i Tempi: 133