Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the battery door at the bottom of the camera.
-
Press down on the door and slide it back. The door will pop open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery from the door that you opened in the previous step.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a PH00 screwdriver and remove the six 2.9mm screws.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use hands to gently pry the front casing away from the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.
-
The second picture shows what these tabs look like in their open positions.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully disengage the internal components from the casing by lifting at the bottom end and giving a gentle tug.
-
The components are still connected to the casing via cables, but they are much more maneuverable.
-
The flash module is shown on the right hand side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the tip of a spudger to flip up the tab on the ZIF connecter securing the motherboard ribbon cable.
-
Grasp the flash module by the bottom and remove it.
-