Salta al contenuto principale

Introduzione

This guide explains how to remove and replace the shutter motor in the Sony Cybershot DSC-P52

  1. Open the battery compartment and remove the batteries.
    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. Open the memory card compartment.
    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. Pull apart the front and back cover pieces carefully.
    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora

    Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora
  6. Open the case as shown.
    • Open the case as shown.

  7. Unclip the clip holding the ribbon cable in.
    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  8. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  9. Remove all six screws on the front side of the motherboard circled in the picture.
    • Remove all six screws on the front side of the motherboard circled in the picture.

    • Pull the motherboard from the rest of the housing.

    • It will still be connected to the flash unit.

  10. Remove the cable on the back side of the motherboard.
    • Remove the cable on the back side of the motherboard.

  11. Detach the ribbon cables shown.
    • Detach the ribbon cables shown.

    • Careful! Touching the leads of the large yellow capacitor can result in a painful shock.

    • Remove the flash unit from the motherboard.

  12. Remove screw securing motor and mount in place.
    • Remove screw securing motor and mount in place.

    • Be careful to leave shutter gears in the correct position

  13. Remove the two screws holding motor to mount/gears.
    • Remove the two screws holding motor to mount/gears.

    • Remove the motor from the mount.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Greg Hermansen

Membro da: 28/01/2011

25 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 3-43, Regan Winter 2011 Membro di Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 4,508