Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Parti

Nessuna parte specificata.

  1. Slide open the battery cover and remove the battery and the Memory Stick Duo. Return the battery cover to its closed position.
    • Slide open the battery cover and remove the battery and the Memory Stick Duo.

    • Return the battery cover to its closed position.

  2. Remove all three screws from the bottom of the camera.
    • Remove all three screws from the bottom of the camera.

  3. Remove the screws on the left and right sides of the camera. Remove the screws on the left and right sides of the camera.
    • Remove the screws on the left and right sides of the camera.

  4. Press down on the flash cover to raise the flash. Remove both screws that hold the flash cover to the body of the camera. Remove both screws that hold the flash cover to the body of the camera.
    • Press down on the flash cover to raise the flash.

    • Remove both screws that hold the flash cover to the body of the camera.

  5. Place the camera upside down with the battery port positioned upward and the battery port open.
    • Place the camera upside down with the battery port positioned upward and the battery port open.

  6. Pry the front cover of the camera off with the plastic opening tool. Pry the front cover of the camera off with the plastic opening tool. Pry the front cover of the camera off with the plastic opening tool.
    • Pry the front cover of the camera off with the plastic opening tool.

  7. Remove the power shutter unit
    • Remove the power shutter unit

  8. Unscrew the screw located at the back left corner of the flash component. Set the flash component aside.
    • Unscrew the screw located at the back left corner of the flash component.

    • Set the flash component aside.

  9. Lift up the gray plastic facing in order to uncover the motherboard and the ribbon cable ports. Lift up the gray plastic facing in order to uncover the motherboard and the ribbon cable ports.
    • Lift up the gray plastic facing in order to uncover the motherboard and the ribbon cable ports.

  10. Carefully flip up the three black clasps holding the lens cables to the motherboard. Slide the cables from the ports.
    • Carefully flip up the three black clasps holding the lens cables to the motherboard.

    • Slide the cables from the ports.

  11. Lift the lens and attached ribbon cables from the camera in order to switch this lens with a new one.
    • Lift the lens and attached ribbon cables from the camera in order to switch this lens with a new one.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Rachel Payne

Membro da: 23/02/2015

356 Reputazione

2 Guide realizzate

Team

USF Tampa, Team 1-1, Leahy Winter 2015 Membro di USF Tampa, Team 1-1, Leahy Winter 2015

USFT-LEAHY-W15S1G1

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 1,935