Salta al contenuto principale

Sony Clie PEG-SL10 Motherboard Replacement

Cosa ti serve

  1. Sony Clie PEG-SL10 Motherboard Replacement, Motherboard: passo 1, immagine 1 di 1
    • Remove the six screws holding the case together.

  2. Sony Clie PEG-SL10 Motherboard Replacement: passo 2, immagine 1 di 1
    • Remove the seven screws holding the motherboard to the device.

  3. Sony Clie PEG-SL10 Motherboard Replacement: passo 3, immagine 1 di 1
    • Unclip the battery harness power cable from the motherboard.

  4. Sony Clie PEG-SL10 Motherboard Replacement: passo 4, immagine 1 di 1
    • Unclip the scroll wheel power cable from the motherboard.

  5. Sony Clie PEG-SL10 Motherboard Replacement: passo 5, immagine 1 di 1
    • Pull the left clip to remove the cable.

  6. Sony Clie PEG-SL10 Motherboard Replacement: passo 6, immagine 1 di 1
    • Pull out the two clips from the center to remove the power cable.

  7. Sony Clie PEG-SL10 Motherboard Replacement: passo 7, immagine 1 di 1
    • Rotate the motherboard toward you to show the cables on the opposite side of the motherboard.

  8. Sony Clie PEG-SL10 Motherboard Replacement: passo 8, immagine 1 di 1
    • Extend both sides of the left clip to remove the power cable.

  9. Sony Clie PEG-SL10 Motherboard Replacement: passo 9, immagine 1 di 1
    • Pull out the center clip to remove the power cable.

  10. Sony Clie PEG-SL10 Motherboard Replacement: passo 10, immagine 1 di 1
    • Pull the right clip out to remove the right cable.

  11. Sony Clie PEG-SL10 Motherboard Replacement: passo 11, immagine 1 di 1
    • The motherboard is removed. To install the new motherboard, follow the directions in reverse.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Emily

Membro da: 10/18/11

3 Reputazione

3 Guide realizzate

Team

James Madison, Team 1-4, Allen Fall 2011 Membro di James Madison, Team 1-4, Allen Fall 2011

JMU-ALLEN-F11S1G4

3 Membri

4 Guide realizzate

Un commento

I have a full reset whenever I take the battery out to recharge it. Given that all replacement motherboards will be as old as the unit, is there anyway to fix the board (I presume it’s a capacitor or super cell that keeps the charge long enough to swap the battery over normally?). The three cells seem to be soldered onto the board, but I presume could be replaced?

Anyone know of a way to fix this?

Benjamin S. Leveritt - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 1,297