Introduzione

We turn our devices on and off every single day, and as such, the buttons wear over time. This repair guide will focus on replacing the electrical components controlling the On/Off buttons.

Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
  • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

Aggiungi Commento

Use a plastic opening tool to pry the cover open.
  • Use a plastic opening tool to pry the cover open.

  • After the the cover is partly open as shown, remove the cover with your hands.

Aggiungi Commento

  • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

Aggiungi Commento

  • Use a plastic opening tool to loosen the back cover off the device.

  • Once the back cover is loose, remove it gently by hand.

Aggiungi Commento

  • Using a spudger, carefully remove the metal casing that is attached to the ZIF connector.

Aggiungi Commento

  • Unclip the two plastic buttons with the spudger tool.

  • The buttons each have a spring under them that will fall off, be careful not to lose them.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Fred Saucedo

Membro da: 11/01/2013

3 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 7-12, Maness Winter 2013 Membro di Cal Poly, Team 7-12, Maness Winter 2013

CPSU-MANESS-W13S7G12

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 212