Salta al contenuto principale

Introduzione

If you are having issues with overheating it is most likely being caused by a faulty fan. In this guide we will open the player up by removing the connecting screws and then removed the faulty fan so it can be replaced for a new one.

Ricambi

Nessuna parte specificata.

  1. Sony BDP-S1 Fan Replacement, Sony BDP-S1: Getting inside the device: passo 1, immagine 1 di 2 Sony BDP-S1 Fan Replacement, Sony BDP-S1: Getting inside the device: passo 1, immagine 2 di 2
    • Remove the 12mm screws with the Philips #2 screwdriver which keep the plastic panels in place.

    • Don't forget, there are two more 12mm screws on the other side as well.

  2. Sony BDP-S1 Fan Replacement: passo 2, immagine 1 di 3 Sony BDP-S1 Fan Replacement: passo 2, immagine 2 di 3 Sony BDP-S1 Fan Replacement: passo 2, immagine 3 di 3
    • First, remove the three 12mm black screws holding the top panel on (Phillips #2).

    • Then, remove the two 12mm black screws - one on each side of the back of the device - holding the top panel on.

    • Lastly, remove the three 12mm black screws on each side of device.

  3. Sony BDP-S1 Fan Replacement: passo 3, immagine 1 di 3 Sony BDP-S1 Fan Replacement: passo 3, immagine 2 di 3 Sony BDP-S1 Fan Replacement: passo 3, immagine 3 di 3
    • Carefully lift up the top panel, because there are two blue ribbon cables that must be disconnected before removing the panel, and we do NOT want them to break.

    • After gently disconnecting the two ribbon cables (you can just pull them out with your hand), take the top off and set it to the side.

  4. Sony BDP-S1 Fan Replacement: passo 4, immagine 1 di 3 Sony BDP-S1 Fan Replacement: passo 4, immagine 2 di 3 Sony BDP-S1 Fan Replacement: passo 4, immagine 3 di 3
    • After the top is off, you'll see that there are two metal bars that go across the top of the device.

    • Remove each bar by unscrewing the two 10mm silver screws on each end.

  5. Sony BDP-S1 Fan Replacement, Fan: passo 5, immagine 1 di 3 Sony BDP-S1 Fan Replacement, Fan: passo 5, immagine 2 di 3 Sony BDP-S1 Fan Replacement, Fan: passo 5, immagine 3 di 3
    • First we need to unscrew the fan from before we can remove it.

    • Remove both copper colored 10mm screws with a #2 phillips screwdriver.

    • As you remove the second screw, pull the fan inward to remove it from the remainder of the case. It should now only be connected to the case through a cable attached to the circuit board.

    • The disk drive is removed in the pictures, however this is not necessary to replace the fan and can be ignored.

  6. Sony BDP-S1 Fan Replacement: passo 6, immagine 1 di 3 Sony BDP-S1 Fan Replacement: passo 6, immagine 2 di 3 Sony BDP-S1 Fan Replacement: passo 6, immagine 3 di 3
    • We will now completely remove the fan from the player.

    • Carefully detach the cable from the fan to the circuit board by pulling on the cable connecting the fan to the circuit board.

    • You are now ready to install the new fan!

Conclusione

To reassemble your device, follow these instructions in reverse order.

Nicolas Kennedy

Membro da: 26/01/2014

111 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 9-30, Maness Winter 2014 Membro di Cal Poly, Team 9-30, Maness Winter 2014

CPSU-MANESS-W14S9G30

3 Membri

5 Guide realizzate

2 Commenti

We're can i get a replacement fan for my Blu- ray player model BDV-E4100. HEEEEELP PLEASE.

darren cottenham - Replica

Where can I get a replacement fan for my blue-ray player.

Christopher Meriweather - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 24

Tutti i Tempi: 2,194