Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect all power cords.
-
Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.
-
Note: the rubber foot and plastic screw guard can be removed as one piece to make reassembly easier
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 10mm Torx T10 screws from the bottom of the speaker.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single 8mm Torx T10 screw and protective cover clip.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the protective cover upwards to remove.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
Un commento
Well done! I would add a little bit about how much adhesive there is underneath the rubber feet as well as the screw cover.