Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board.
-
Lift or slide the binding off the board and set the screws aside.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a 5.5mm flathead screwdriver to anchor the backing bracket located on the inside of the binding.
-
Using a Phillips #2 screwdriver, unscrew the countersunk ovalhead M4 x 16mm screw connecting the heel strap ladder to the binding.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the 10mm long thumb screw connecting the heel strap with its binding connector.
-
Pull the heel strap apart from its binding connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a 5.5mm flathead screwdriver to anchor the backing bracket located on the inside of the binding.
-
Using a Phillips #2 screwdriver, locate and unscrew the countersunk ovalhead M4 x 16mm screw holding the heel strap connector to the binding.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the binding so that the bottom is accessible.
-
Using your hands, pry off the plastic bottom covering starting at the toe end.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the corner foam coverings by grabbing one edge and lifting up.
-
Slide out the toe strap ladder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #2 screwdriver, unscrew the button head M4 x 10mm screw holding the toe strap with its connector.
-
Slide the toe strap off of the toe strap connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the binding on its side and slide out the toe strap connector.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.