Introduzione

This guide will show how to take apart and repair the small engine recoil starter on a lawn mower.

Parti

Nessuna parte richiesta.

  1. To begin the repair remove the protective casing. (This removal may vary with different lawnmowers.)
    • To begin the repair remove the protective casing. (This removal may vary with different lawnmowers.)

  2. Locate the recoil housing cap.
    • Locate the recoil housing cap.

  3. Carefully remove the housing cap. (Removal may vary)
    • Carefully remove the housing cap. (Removal may vary)

  4. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. After removing the recoil, unscrew the cap that holds the pulley to the recoil starter housing.
    • After removing the recoil, unscrew the cap that holds the pulley to the recoil starter housing.

  6. Untie the knot in the rope and slide it out of the housing.
    • Untie the knot in the rope and slide it out of the housing.

  7. With this particular model there is a middle lock piece. Use a socket wrench to unscrew and release the coil.
    • With this particular model there is a middle lock piece. Use a socket wrench to unscrew and release the coil.

  8. Once unscrewed, remove the metal piece which releases the tension on the coil.
    • Once unscrewed, remove the metal piece which releases the tension on the coil.

  9. At this point add the new coil to the housing base. Snap the coil into position where the old on was.
    • At this point add the new coil to the housing base. Snap the coil into position where the old on was.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 41

Tutti i Tempi: 809