Parti

Nessuna parte richiesta.

Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.
  • Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.

Aggiungi Commento

While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.
  • While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.

Aggiungi Commento

  • Grip cordless drill firmly with left hand. Grip the cordless drill handle firmly with the right hand. Rotate the handle counterclockwise in order to remove the handle from the drill.

Aggiungi Commento

  • The chuck sleeve is held on by a 20mm Phillips #2 screw in the center.This screw is reverse threaded. Insert a Phillips #2 screwdriver and rotate it clockwise to loosen and remove it.

Aggiungi Commento

  • The threaded hole the screw was in is in the shape of a 6-point star. Insert a T40 Torx Key and rotate it clockwise to loosen and remove the chuck sleeve.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jameson

Membro da: 23/09/2014

228 Reputazione

2 Guide realizzate

Team

USF Tampa, Team 2-3, Blackwell Fall 2014 Membro di USF Tampa, Team 2-3, Blackwell Fall 2014

USFT-BLACKWELL-F14S2G3

5 Membri

7 Guide realizzate

For my drill, the Torx screw had to be rotated *counter-clockwise to remove. I'm not sure if that was an error in step #5 or some drills are different.

Thank you for the location of those screws btw.

"Step 5 — Remove the chuck sleeve

The threaded hole the screw was in is in the

shape of a 6-point star. Insert a T40 Torx Key

and rotate it *clockwise to loosen and remove

the chuck sleeve."

Joe Bailey - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 9

Tutti i Tempi: 596