Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Sidekick II Keyboard Replacement

Introduzione

To take the key board out for replacement.

Cosa ti serve

  1. Sidekick II Keyboard Replacement, Outer Casing: passo 1, immagine 1 di 1

    • Use the plastic opening tool to remove the 4 buttons on each corner of the Sidekick.

    • Gently pry open button and remove button.

    • Do this for each of the 3 buttons remaining.

    Traduci

  2. Sidekick II Keyboard Replacement: passo 2, immagine 1 di 2 Sidekick II Keyboard Replacement: passo 2, immagine 2 di 2

    • The bumpers on the top and bottom of the phone can be removed by simply "peeling" them off.

    Traduci

  3. Sidekick II Keyboard Replacement: passo 3, immagine 1 di 1

    • Use the T6 Torx Screwdriver to remove the 4 screws that are underneath the 4 buttons you removed in step one.

    Traduci

  5. Sidekick II Keyboard Replacement: passo 4, immagine 1 di 1

    • Flip the screen up halfway (90 degrees), to reveal the 2 screws above the right side of the keyboard.

    • Use the Torx 6 screwdriver to remove these 2 screws.

    • Be careful in handling the phone after removing the screws, because the two main bodies of the phone are no longer attached.

    Traduci

  6. Sidekick II Keyboard Replacement: passo 5, immagine 1 di 1

    • After removing the 6 screws and both bumpers, the phone will be easy to separate into the two main bodies.

    • You can use your hands to simply pull apart the top casing from the bottom casing.

    Traduci

  7. Sidekick II Keyboard Replacement, Keyboard: passo 6, immagine 1 di 2 Sidekick II Keyboard Replacement, Keyboard: passo 6, immagine 2 di 2

    • Remove screen from case

    Traduci

  8. Sidekick II Keyboard Replacement: passo 7, immagine 1 di 1

    • Remove both black "rivets" from the back of the case with the plastic opening tool.

    Traduci

  9. Sidekick II Keyboard Replacement: passo 8, immagine 1 di 1

    • Push keyboard out of the front of the casing with your thumbs.

    • Make sure not to press too hard; you may break the board.

    Traduci
Linea Traguardo

Autore

con 5 altri collaboratori

michael albaum

Membro da: 01/20/10

87 Reputazione

6 Guide realizzate

Distintivi: 9

+6 altri distintivi

Team

Cal Poly, Team 3-19, Maness Winter 2010 Membro di Cal Poly, Team 3-19, Maness Winter 2010

CPSU-MANESS-W10S3G19

4 Membri

11 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,947