Introduzione

The faceplate connects all of the internal wiring of the microphone. If it is defective (or wires need to be reattached to it), this guide shows how to replace it.

Parti

Nessuna parte richiesta.

  1. Remove the yellow and green wires from the face plate.
    • Remove the yellow and green wires from the face plate.

    • Note which side the yellow and green wires connect to.

  2. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  3. Never open the microphone capsule. Attempting to open the capsule will likely result in permanent damage and make the microphone unusable. Using an adjustable crescent wrench, remove the nut and washer from the face plate by twisting the nut counterclockwise.
    • Never open the microphone capsule. Attempting to open the capsule will likely result in permanent damage and make the microphone unusable.

    • Using an adjustable crescent wrench, remove the nut and washer from the face plate by twisting the nut counterclockwise.

  4. Slide the face plate over the connector. Slide the face plate over the connector.
    • Slide the face plate over the connector.

Conclusione

Follow the steps of the guide in reverse to reassemble the microphone. In order to solder wires back to faceplate use soldering guide.

nat coll

Membro da: 27/09/2012

384 Reputazione

14 Guide realizzate

Team

Cal Poly, Team 7-53, Forte Fall 2012 Membro di Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Membri

18 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 71

Tutti i Tempi: 6,219