Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws at the back of the iron.
-
Remove the back cover piece.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws holding the white clamp to the iron.
-
Remove the two screws holding the black wires to the body of the iron.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the split end of the power cord upward through the ball joint of the iron.
-
Set aside power cord.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove remaining screws that hold a wire on the bottom (brown and blue).
-
Unscrew from left to right.
-
Unclip the black adapter piece on the bottom right.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two screws (left and right) affixed to circuit board.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
3 Commenti
i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace
I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks
Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?