Aggiusta la tua roba ComunitĂ  Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Shark Ultimate Professional Reservoir Replacement

Cosa ti serve

  1. Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, immagine 1 di 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, immagine 2 di 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, immagine 3 di 3

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

    Traduci

  2. Shark Ultimate Professional Reservoir Replacement: passo 2, immagine 1 di 2 Shark Ultimate Professional Reservoir Replacement: passo 2, immagine 2 di 2

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

    Traduci

  4. Shark Ultimate Professional Reservoir Replacement: passo 3, immagine 1 di 1

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

    Traduci

  5. Shark Ultimate Professional Reservoir Replacement: passo 4, immagine 1 di 3 Shark Ultimate Professional Reservoir Replacement: passo 4, immagine 2 di 3 Shark Ultimate Professional Reservoir Replacement: passo 4, immagine 3 di 3

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

    Traduci

  6. Shark Ultimate Professional Reservoir Replacement: passo 5, immagine 1 di 2 Shark Ultimate Professional Reservoir Replacement: passo 5, immagine 2 di 2

    • Remove two screws (left and right) affixed to circuit board.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Autore

con 1 altro collaboratore

Drew Carff

Membro da: 10/23/17

868 Reputazione

5 Guide realizzate

Distintivi: 14

+11 altri distintivi

Team

USF Tampa, Team S1-G4, Leahy Fall 2017 Membro di USF Tampa, Team S1-G4, Leahy Fall 2017

USFT-LEAHY-F17S1G4

3 Membri

10 Guide realizzate

3 Commenti

i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace

primrose33166 - Replica

I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks

Dalmacca-Hame - Replica

Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?

Muhammad Ahmad - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 19

Tutti i Tempi: 2,135