Shark Rotator Powered Lift-Away Speed Headlight Replacement

Introduzione

The Shark Rotator Powered Lift-Away has two LED headlights to assist in vacuuming in poorly lit areas. The vacuum's headlights are designed to last approximately 7 years. Replacement of the headlights is needed to keep the vacuum at optimal condition. This replacement guide demonstrates how to replace both LED headlights in the vacuum.

Cosa ti serve

Passo 1 Headlight

Shark Rotator Powered Lift-Away Speed Headlight Replacement, Headlight: passo 1, immagine 1 di 2

Shark Rotator Powered Lift-Away Speed Headlight Replacement, Headlight: passo 1, immagine 2 di 2

Flip the vacuum on its underside, and use a coin to rotate the cam-screws on the bottom panel so that their grooves are parallel with the front of the vacuum.

Modifica

Passo 2

Squeeze the sides of the roller brush cover release clasp, and swing the cover open.

Modifica

Passo 3

Using a T20 screwdriver remove five 15.9 mm screws on the outside of the cover.

Modifica

Passo 4

Using a T20 screwdriver, remove three 13.4 mm screws from where the roller brush cover attaches to the bottom of the vacuum.

Modifica

Passo 5

Using a T20 screwdriver, remove two 13.4 mm screws from under the wheels.

Modifica

Passo 6

Using a T20 screwdriver, remove two 15.9 mm screws behind the vacuum wheels.

Modifica

Passo 7

Using a PH0 screwdriver bit, remove the single 13.4 mm screw in between the roller brush and where the release clasp was attached.

Modifica

Passo 8

Using a T20 screwdriver, remove the single 13.4 mm screw from behind the belted end of the roller brush.

Modifica

Passo 9

Shark Rotator Powered Lift-Away Speed Headlight Replacement: passo 9, immagine 3 di 3

Flip the vacuum into the upright position, and use a spudger to open the front assembly cover by prying the seam where the colored front assembly and the grey side covers meet.

Modifica